Jump to content
Sign in to follow this  

Help with booting Yosemite without having to enter convoluted code each time

Recommended Posts

I'm new to this but have managed to figure out how to install Yosemite onto my computer.

It took hours of reading and problem solving but I eventually managed to install it and run it by booting using this code:


npci=0x3000 PCIRoot=0 PCIRootUID=1 cpus=1 maxmem=2048 USBBusFix=Yes nv_disable=1 GraphicsEnabler=No IGPEnabler=No "Graphics Mode"="1024x768x32@60" UseKernelCache=No


But it seems as though I have to enter this each time I boot in order for it to work. Not to mention how sluggish the computer operates when I do it this way! (The specs way exceed minimum requirements).

Basically, I've got this far but don't know how to go about getting the computer to perform normally.

I apologise in advance for my minuscule knowledge.


Any help is much appreciated,




Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community.

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Create New...