Jump to content
Sign in to follow this  

Debugger not config hanging in Yosemite

Recommended Posts

While installing Yosemite zone i am facing some issues

When i used -v flag, setup ran but got hanged within seconds and debugger not config msg displayed

When i used -v -x, no setup ran and in that dos type screen only it displayed debug not config

When i used -v -x GraphicsEnabler=no, setup ran but setup kinds of get partially hang. I was able to move my mouse and select languages but i wasn't able to go further

When i used -v -x GraphicsEnabler=no cpus=1, setup ran completely and i finally set my niresh to install but on 14 minute left(after stuck at 14 mins for more than 2-3 mins). Msg displayed debugger not config hanging(msg displayed like a dos type lines on a gui setup i hope you understood)

My pc config:-

intel i7 4790k OC

Amd FirePro W7000. //graphic card

Asus Sabertooth Z97 Mark II. //motherboard

Corsair 8x2

I previously installed Mavericks 10.9 and it installed completely fine just i was having some issues with sound, i dont know about network because i dont have ethernet connection, i have netgear wireless adapter which i knew very well that it cant get installed on a mac

Share this post

Link to post
Share on other sites
My problem is almost the same , but when I type " / haswell cpus = 1" ... sometimes carries everything , but when I click install, after 3 min. stop and appears message misses dixendo that may not like to proceed etc.

Notebook HP Pavilion 14-vo67 br

Core™ i7-4510U, Windows 8.1, 4GB, 1TB, 840m 2GB, Beats Audio, LED 14"

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community.

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Create New...